This painted brick exterior repaint on Sea Island covered the brick walls, board and batten siding, trim, metal walkway ceiling, steel windows and a metal clad bay window. Every surface was matched to its existing color, and the work started once the homeowners’ new windows were in.
Project at a glance
- Location: Sea Island, GA
- Project type: Residential exterior repaint
- Surfaces: Painted brick, board and batten siding, soffits, fascia, vents, posts, garage doors and trim, front gate, metal walkway ceiling, steel windows and lintels, metal clad bay window, stained front door
- Colors: Matched to the existing colors
- Added work: New window trim, rotted wood repairs, garage doors, decorative ironwork
- Completed: November 2026
Why the homeowners called
The homeowners wanted the whole exterior repainted, and they were also replacing their windows. We held the project until the new windows were installed, then started on October 5, the date they chose. The new windows came with wood trim where they meet the brick, so we added prep and paint for that trim to the job.
What we did
- Washed the entire house, the stone patio and the covered walkway with a house wash and chlorine solution to remove mildew, spider webs and dirt
- Scraped loose paint and sanded surfaces smooth
- Caulked cracks in the trim and in the brick mortar joints
- Primed raw wood, rusted nails, bare metal and chalky brick
- Applied the finish coats, matched to the existing colors
- Cleaned, caulked, primed and painted the new window trim at the brick
Rusted metal gets a rust inhibitive primer before any finish coat goes on, and chalky brick gets a masonry bonding primer so the new paint has a sound surface to grip. Learn more about our exterior painting on Sea Island.
Prep and coatings on a painted brick exterior with wood and metal
Each material on this house got its own prep and its own coating:
- Brick walls: Loose paint scraped, mortar cracks caulked with elastomeric caulk, exposed or chalky areas primed with Loxon masonry bonding primer, then two coats of 100% acrylic low luster latex
- Board and batten siding: Scraped, sanded, raw wood and rusted nails primed, then 100% acrylic low luster latex
- Soffits, fascia, vents, posts, garage door trim and front gate: Scraped, sanded, caulked, spot primed, then 100% acrylic satin latex
- Metal walkway ceiling, steel windows and steel lintels: Scraped, sanded, one coat of Rust Bond two-component rust inhibitive primer, then two coats of Carboline two-component satin urethane
- Metal clad bay window: Loose metal stiles reattached, scraped, sanded, caulked, DTM wash primer, then two coats of high performance acrylic urethane
- Front entry door: Sanded, stain touched up, then two coats of marine grade exterior urethane

Work the homeowners added during the job
- Painted the garage doors (the original scope covered only the trim around them)
- Prepped and painted four pieces of decorative ironwork, plus the decorative metal work over the kitchen sink
- Our carpenter replaced rotted wood in two areas the homeowners asked us to fix, then we primed and painted them. See our rotted wood repair service.
The result
The brick, siding, trim and metal all have fresh finishes in the colors the homeowners already had, and the covered walkway ceiling is clean and smooth again. In their Google review, the homeowners said D&D was “extremely thorough in the prep and painting as well.”






Swipe or scroll sideways to see all 5 photos
What the homeowners said
“D&D just finished painting the exterior of our house. They were extremely thorough in the prep and painting as well. I highly recommend using them for your painting needs.”
Homeowner, Sea Island
Read the full review on Google
Questions about a project like this
Can you repaint a painted brick house?
Yes. On this home we caulked cracked mortar joints with elastomeric caulk, primed exposed or chalky brick with Loxon masonry bonding primer, and applied two coats of 100% acrylic low luster latex.
Can rusted metal ceilings and steel windows be repainted?
Yes. The metal walkway ceiling, steel windows and steel lintels were scraped, sanded, primed with a two-component rust inhibitive primer and finished with two coats of two-component satin urethane.
Should I paint before or after replacing my windows?
On this job we started after the new windows were installed, so the new window trim could be primed and painted along with the rest of the house.
Can I add work after the job starts?
Yes. These homeowners added the garage doors, the decorative ironwork and two rotted wood repairs while the crew was on site.
Planning a similar project on Sea Island?
If your home has peeling paint, rusting metal or new windows that need trim painted, we can walk the property with you and give you a written estimate at no charge. See more of our work on Sea Island.
More projects nearby: a Navajo White interior repaint with repairs on Sea Island and a Farrow & Ball primary suite repaint on Sea Island.
Every project is backed by our 3-Year Coastal Warranty. Creating delighted customers since 1986.












